World's Foremost MedEvac Manufacturer

MedStar Series

Common Features of the MedStar Series:
  • Lightweight aluminum honeycomb base; lightest weight air ambulance base available
  • Durable
  • Ten to fifteen minutes to install or remove the Medstar base

Base accessories available:
  • Oxygen
  • Air
  • Vacuum
  • Electrical service; 110 vac, 220 vac, 28 vac
  • Drawers or shelves optional---1 to 4 drawers / shelves,
  • Heated and/or locking for draws & shelves available

Stretcher:
  • Honeycomb plate with tubular aluminum frame
  • Four point harness, lap and leg belts
  • Simple locking mechanism to the MedStar base
  • Upper torso (back rest) raises and lowers using an exceptionally strong mechanism
  • Patient backrest is the correct length to support the patient’s back and neck
  • Folding IV pole
  • Optional extra wide stretcher available

Digital Control and Switch Panel (with Medstar Series Only):

  • Available in US and Metric readouts
  • Push button on/off micro switches
  • Read Out Display - inc. Cabin Pressure, Altitude, Air Pressure, Suction, Inverter Voltage, Tank Pressure (optional)

Our digital control & switch panel unit can be mounted virtually anywhere on the aircraft. The information is relayed from the ICU bed electronically.
The touch pad controls are easier to use than other conventional type equipment. The digital display system is far more accurate than traditional analog gage systems and is the only one of its kind in the industry to use this technology.



MedStar bases may be fabricated to meet fixed wing and helicopter requirements. Honeycomb aluminum has the advantage, versus traditional construction, of being molded as sheets with rivets and epoxy. Honeycomb aluminum construction does not have bolts and screws that may cause noise over time. Honeycomb aluminum has a distinct weight advantage versus aluminum bar and panel… weight savings that every aircraft should take advantage of.

Please see our example kits for a listing of commonly ordered units. All orders are custom built so most features can be added or deleted from any presented configuration.

We can also offer benches that are certified for takeoff and landing for up to three people. The bench can be converted into a full air ambulance unit in just a couple of minutes.

Other custom units can be built like double base units. Do you need something customer to meet a unique need? Just ask us about your situation.


Product Features for both the Medstar & Classic series bases

Base unit:
  • True 10 minute installation and removal
  • Designs for modest floor to ceiling height aircraft
  • Optional custom bases with drawer or shelf storage capacity
  • Specific units for installation over rear fold down seats or center spars

Oxygen:
  • Remote fill port. Fill port mounted on the face or end of the base. The oxygencylinder remains secured.
  • 3500 to 10000 liters capacity
  • Flow meter and high pressure outlets
  • Easy to read Oxygen Remaining gauge
  • Oxygen outlets; flow meter receptacle, 50 psi DISS, special order outlets
  • Optional European High Pressure cylinders and plumbing
  • Optional Kevlar tanks available

Electrical Inverter:
  • 115 vac and 230 vac inverters
  • 330 watts through 1500 watts
  • Two or four electric outlets on the face or end cap of the base unit
  • Simple wiring to the aircraft electric bus
  • Lighted On / Off switches or Optional Digital Display
  • Circuit breaker protected.
  • Wiring Kit. The Wiring Kit carries electric power from the aircraft electricalsystem to the aircraft cabin for connection to the Medstar or Classic base unitinverter. The wiring kit has a relay, wiring, canon plug and instructions. Thewiring kit is installed by the aircraft’s technicians.

Vacuum (Suction) Pump and Compressed Air Pump:
  • Pumps are wired for 28v aircraft power operation. Pumps are independent of inverter operation
  • Vacuum pump develops 20 inches (508 mm) Hg of suction at 3.3 amps
  • Compressed air pump delivers 19.8 liters per minute at 3.3 amps
  • Convenient lighted On / Off switch
  • Medical gas outlet
  • Circuit breaker protected

Stretcher and Mattress, Comfort and Stability for the Patient:
  • Stretcher is built from honeycomb and tubular steel
  • Mattress is fire blocked and covered in a very durable fabric
  • Mattress padding is available from 2” thick to 6” thick
  • Stretcher locks into the base unit the same as car doors close and lock
  • Four point upper torso harness and lap and leg belts
  • Stretcher is tapered head and foot, preventing scraping the aircraft doorseals and side walls
  • Extra wide stretchers available for larger patients

Accessories & Features:
  • Up to four drawers or shelves in a base unit
  • Locking base unit shelves / drawers
  • Equipment storage cabinets for easy retrieval of stored equipment
  • Lip and curtain restraint
  • Overhead and vertical Patient Care Centers
  • Outlets for air, oxygen, vacuum and electrical
  • Flexible LED lighting to assist with patient care
  • No across the patient cables
  • No across the stretcher platform inhibiting stretcher loading and unloading
  • Mounting tracks, bars, & shelves for equipment
  • Available as permanent installation to the aircraft wall or as part of the base unit

AERO MEDICAL Inc..
11733 66th St., Unit 111
Largo, FL
- USA 33773

main: 1.727.623.9733
cel: 1.262.305.4247
sales@medicalaircraft.com